DripTech Eco-Flow | Irrigation equipment in Kenya

Farm water pan construction, sizing and lining in Kenya

Farm water pan construction, sizing and lining in Kenya - irrigation equipment and farm setup in Kenya

Rainwater harvesting in lined farm water pans allows Kenyan growers to irrigate high-value crops through dry spells. Proper siting, stable bank slopes, silt traps and UV-stabilized HDPE lining keep the reservoir safe and watertight.

Key engineering checks before excavating a water pan

  • Size the reservoir storage volume (m³) against your crop area, daily water demand and dry-season days
  • Shape stable side slopes (commonly 1:1.5 to 1:2 depending on soil stability) so banks do not collapse
  • Construct a settling silt trap at the runoff inlet so sand and debris do not fill the lined pan
  • Build a reinforced overflow spillway to discharge excess storm runoff safely without washing out the embankment
  • Compact and dress the floor and walls to remove sharp stones, tree roots and protrusions before laying the liner

Estimating storage capacity vs irrigated crop area

A water pan must store enough cubic metres to cover both crop evapotranspiration and surface evaporation over the dry period. Pairing the pan with drip irrigation and mulch stretches stored water much further than overhead flood or high-loss watering.

Water pan planning considerations for Kenyan farms
ComponentEngineering purposeWhat to check on site
Inlet channel & silt trapTraps heavy sediment before water enters the panClean out silt after major rain events
HDPE geomembrane linerStops seepage losses through porous soilSelect 0.5mm, 0.75mm or 1.0mm based on soil texture
Perimeter anchor trenchSecures the liner around the top bankUsually 40–50 cm deep and set back from the slope edge
Floating pump intake & filterDraws cleaner surface water into the irrigation pumpPair with a disc or screen filter before drip lines

Safety, fencing and routine maintenance

Always fence lined water pans to keep people, livestock and wildlife safe and to prevent hooves from puncturing the HDPE liner. Install a safe draw-off pipe or solar pump intake so workers never need to walk on the wet liner slope.

Frequently asked questions

Why should a water pan have sloped walls instead of vertical walls?

Sloped banks prevent soil collapse during rain or drawdown and allow the HDPE dam liner to rest evenly against the earth without excessive tension.

How do I filter water drawn from an open water pan for drip irrigation?

Use a floating intake strainer to draw water below the surface scum layer and above bottom sediment, followed by an appropriately sized disc or screen filter.

Products you can use for this

Browse all irrigation products or ask DripTech to size a system for your farm.